Maktek OMEGA, Инструкция по установке и обслуживанию

Страница: 28 / 45

4.2 STARTING UP
First time operation of the boiler must be done by authorised service personel in order to
validate the guarantee of the boiler and to ensure the boiler runs efficiently and safely
for many years.
Authorized service personnel will check all requirements in the startup request form,
which must be filled by the installer before the service comes to validate the boiler for
first time operation.
If any of the requirements are not met, ther service will not put the boiler into operation
and will ask the user to complete installation requirements. The user then should contact
the installer and make sure that all the conditions of the starup request form are met.
When the installation meets all the requirements, the service personnel will put the boiler
into operation and manufacturer's warranty will be validated. The manufactuere is not
responsible for any failures or damages on boilers which are not validated by authorized
service.
The following steps will be taken to put the boiler into operation:
a) Check that the main circuit breaker and RCD device switches are on.
b) Check that the valves of the heating circuit and DHW installation are open.
c) Set the P2 key to the desired position from the OFF position and set the desired water
temperature by following the thermometer reading on the display.
d) You can set the DHW temperature using the P1 key. The adjusted temperature is
shown on the display.
The boiler will start operation automatically according to the adjustments made on the
control panel. Detailed explanation about making operation adjustments are given in
section 5, user instructions.
25