Maktek OMEGA, Инструкция по установке и обслуживанию

Страница: 10 / 45

3.MOUNTING AND INSTALLATION
3.1 UNPACKING
Open the box as seen in the above sketch. Place the box on the ground, arrows on the
box pointing to the ground. Cut the cords or remove the staples, fold the lids of the box
on each side and turn the box upside down. Pull the box upwards and remove it.
3.1.1 Delivery Content
3.2 INSTRUCTIONS FOR MOUNTING
Boiler should not be installed in humid places such as bathrooms and areas that may
be affected by rain water.
The boiler should be installed on strong walls that can carry it and perpendicular to the
ground.
Spesific space must be left around the for the authorized service to intervene in the
event of a technical breakdown or maintenance. You can find the minimum spaces
required for installation in the below diagram.
Only use the wall plugs, screws and wall mounting plate supplied with the device during
installation.The boiler must be installed vertically (upright position) and checked with a
spirit level so that it can work properly after installation. Failure to do so will invalidate
the warranty.
3.3 MINIMUM SPACES FOR INSTALLATION
At least the following space must be left in order to reach the internal parts of the
device easily when a failure occurs or when maintenance is carried out.
Suggested space is the minimum space and it is favorable to leave more space
depending on the situation.
7
1
RCD Device Box
2
4x30 Wood Screw
2
6 mm Wall Plug
6-40 kW 50-100 kW
1
RCD Device
1
Documents Pack
4
10x50 Wall Plug
4
M7x50 Screw
DESCRIPTION
1
Electrical Combi Boiler
1
Wall Mounting Plate
QTY
DESCRIPTION
1
Electrical Combi Boiler
QTY
4
M7x50 Screw
1
Wall Mounting Plate
1
Documents Pack
4
10x50 Wall Plug