Maktec MT955, Инструкция по эксплуатации

Страница: 9 / 32

9
WARNING:
• When using an abrasive cut-off/diamond wheel, be
sure to use only the special wheel guard designed for
use with cut-off wheels.
• NEVER use cut-off wheel for side grinding.
• Do not “jam” the wheel or apply excessive pressure.
Do not attempt to make an excessive depth of cut.
Overstressing the wheel increases the loading and
susceptibility to twisting or binding of the wheel in the
cut and the possibility of kickback, wheel breakage and
overheating of the motor may occur.
• Do not start the cutting operation in the workpiece.
Let the wheel reach full speed and carefully enter into
the cut moving the tool forward over the workpiece
surface. The wheel may bind, walk up or kickback if the
power tool is started in the workpiece.
• During cutting operations, never change the angle of
the wheel. Placing side pressure on the cut-off wheel
(as in grinding) will cause the wheel to crack and break,
causing serious personal injury.
• A diamond wheel shall be operated perpendicular to
the material being cut.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
Replacement of carbon brushes (Fig. 11)
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep the
carbon brushes clean and free to slip in the holders. Both
carbon brushes should be replaced at the same time. Use
only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
(Fig. 12)
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by
Makita Authorized Service Center.
16 mm (5/8”)
20 mm (13/16”)
22.23 mm (7/8”) 22.23 mm (7/8”) 22.23 mm (7/8”) 22.23 mm (7/8”)
16 mm (5/8”)
20 mm (13/16”)
1
2
3
1
4
3
100 mm (4”)
115 mm (4 - 1/2”) / 125 mm (5”)
1
2
3
1
4
3
Abrasive cut-off wheel
Diamond wheel
Thickness: Less than 4 mm (5/32”) Thickness: 4 mm (5/32”) or more
Thickness: 4 mm (5/32”) or more Thickness: Less than 4 mm (5/32”)
Thickness: Less than 4 mm (5/32”) Thickness: 4 mm (5/32”) or more Thickness: Less than 4 mm (5/32”) Thickness: 4 mm (5/32”) or more
Abrasive cut-off wheel Diamond wheel
1. Lock nut 2. Abrasive cut-off wheel 3. Inner flange 4. Diamond wheel
1. Lock nut 2. Abrasive cut-off wheel 3. Inner flange 4. Diamond wheel