Maktec MT955, Инструкция по эксплуатации

Страница: 4 / 32

4
ENGLISH (Original Instructions)
Explanation of general view
SPECIFICATIONS
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
END202-6
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
...... Read instruction manual.
................ DOUBLE INSULATION
...... Wear safety glasses.
Intended use
ENE048-1
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
ENF002-1
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
General Power Tool Safety
Warnings
GEA005-3
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
The term “power tool” in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust.
Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
operating a power tool.
Distractions can cause you
to lose control.
Electrical safety
4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools.
Unmodified plugs and matching outlets will
reduce risk of electric shock.
5. Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators.
There is an increased risk of electric
shock if your body is earthed or grounded.
6. Do not expose power tools to rain or wet
conditions.
Water entering a power tool will increase
the risk of electric shock.
7. Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
moving parts.
Damaged or entangled cords increase
the risk of electric shock.
8. When operating a power tool outdoors, use an
extension cord suitable for outdoor use.
Use of a
1. Press
2. Slide switch lever
3. Wheel guard
4. Bearing box
5. Screw
6. Lock nut
7. Depressed centre wheel
8. Inner flange
9. Spindle
10. Lock nut wrench
11. Shaft lock
12. Abrasive cut-off wheel/diamond
wheel
13. Wheel guard for abrasive cut-off
wheel/diamond wheel
14. Limit mark
15. Brush holder cap
16. Screwdriver
Model MT951 MT952 MT953 MT955
Wheel diameter 100 mm 115 mm 125 mm 100 mm
Rated speed (n)/No load speed (n
0
) 12,000 min
-1
10,000 min
-1
10,000 min
-1
11,000 min
-1
Overall length 266 mm 266 mm 266 mm 276 mm
Net weight 1.8 kg 2.0 kg 2.0 kg 2.0 kg
Safety class /II