Maktec MT372, Инструкция по эксплуатации, Страница: 7 / 32

7
ENGLISH
Explanation of general view
SPECIFICATIONS
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
END201-7
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
.... Read instruction manual.
.............. DOUBLE INSULATION
ENE010-1
Intended use
The tool is intended for flush trimming and profiling of
wood, plastic and similar materials.
ENF002-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
GEA005-3
General Power Tool Safety
Warnings
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
The term “power tool” in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust.
Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
operating a power tool.
Distractions can cause you
to lose control.
Electrical safety
4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools.
Unmodified plugs and matching outlets will
reduce risk of electric shock.
5. Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators.
There is an increased risk of electric
shock if your body is earthed or grounded.
6. Do not expose power tools to rain or wet
conditions.
Water entering a power tool will increase
the risk of electric shock.
7. Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
1. Base
2. Scale
3. Bit protrusion
4. Clamping screw
5. Switch lever
6. Loosen
7. Tighten
8. Hold
9. Workpiece
10. Bit revolving direction
11. View from the top of the tool
12. Feed direction
13. Straight guide
14. Clamping screw (A)
15. Adjusting screw
16. Clamping screw (B)
17. Trimmer guide
18. Chip deflector
19. Guide holder
20. Screwdriver
21. Base protector
22. Screws 23. Bit
24. Templet
25. Templet guide
26. Bolt
27. Guide plate
28. Wing nut
29. Center hole
30. Nail
31. Guide roller
32. Limit mark
33. Brush holder cap
Model MT372
Collet chuck capacity 6.35 mm (1/4") or 6.0 mm
No load speed (min
-1
) 35,000
Overall length 199 mm
Net weight 1.4 Kg
Safety class /II