9
3 Installation
For packaging reasons, the machine is not completely assembled.
If you notice any damage caused by transportation while opening the package, notify your supplier
immediately. Do not operate the machine.
Dispose of the packing in an environmentally friendly manner.
The sander is designed to operate indoors and must be placed on a firm, stable and level surface.
CAUTION: To prevent the machine from moving and causing a lack of precision, make sure that the
base on which it is supported is not uneven. If the machine moves on the surface, place a support
under the base until it is firmly on the surface.
3.1 Unpacking
Due to modern mass production techniques, the MAKSIWA LDF sander is unlikely to have
defect or a part is missing. If you find something wrong, don’t use the tool until parts are replaced,
or failure is corrected. By doing this you are avoiding serious bodily injury.
1. Remove all loose parts from the packaging.
2. Remove the packaging materials around the parts.
3.
Carefully lift the main frame of the and place it on a flat surface.
4. To mount the base, use the two side panels (A) and the front (B) and rear (C) panels using 8 hex
bolts, 16 washers, 8 washers and thrust and 8 hex nuts, as shown in the following figure.
