13
13. Install the Guard Guard (A). This item should be installed to ensure safety during operations.
Proceed as follows: Remove fully the handles (B) on each side. Insert the Protection Guard (A)
below the parts (C). Align the Guard with the holes and reinstall the 2 handles (B). See the figure
below. If you want to sand on internal curves that require the use of this part of the sandpaper,
do not install this item, but be sure to take the appropriate adequate security.
3.2 Connection Test
Complete this process only after you have familiarized yourself with all the instructions in this manual.
To test, follow these steps:
1.
Read the entire instruction manual first, to that you are familiar with all the controls and functions
of the MAKSIWA LDF sander.
2. Connect the machine to the power source.
3.
Turn the switch to the ON position. The sander must run smoothly, with little or no vibration.
Right after turning the machine off, if you suspect any problem, correct these problems before
turning it on again.
