18
6.2 Lubrication
Since all bearings are shielded and have permanent lubrication, just leave them this way until they
need to be replaced. Do not lubricate. For the other items on this machine, an application occasional
electric machine oil is all that is required. Before applying the lubricant, clean the sawdust. Its
objective is to achieve adequate lubrication. Too much lubrication will attract dirt and sawdust.
Various parts of your machine can lose your freedom to excessive dirt movement caused by over-
lubrication.
6.3 Maintenance Schedule
Daily:
•
Vacuum all the dust from above and around the machine.
• Clean the table and all unpainted cast iron with a metal protector.
Monthly:
• Check the motor belt tension, checking damage or wear.
• Clean the accumulation of dust inside and outside the engine.
6.4 Sandpaper Replacement
The tape sandpaper must be replaced since excessive wear, tears or holes. For replace it, follow the
instructions below:
1.
Before removing the used sandpaper, it is necessary to some parts first.
2. Remove the Final Protection Guard (A) and Guard Bottom Protection (B), remove the 4 handles
(C).
