MAKSIWA DE.1200/3, Инструкция по эксплуатации

Страница: 8 / 14

8
Starting the machine:
1. Read the entire instruction manual.
2. make sure the cutterhead guard is installed and
correctly adjusted.
3. Make sure all tools and foreign objects have been
removed from the machine.
4. Connect your machine to the power source.
5. Press the START button to turn the machine ON
- The jointer should run smoothly with little or no
vibration;
- Immediately stop the jointer if you suspect any
problems and to troubleshoot/fiz any problems
before starting the jointer again.
Recommended Adjustments
For your convenience the adjustments listed below
have been performed at the factory and no futher
setup is required to operate your machine.
However because of the manu variables involved with
shipping, we recommend that you at least verify the
following adjustments to ensure the best possible
results from your new machine.
Step-by-step instructions for these adjustments can
be found in SECTION 4.
Factory adjustments that should be verified:
1. Knife Settings.
2. Depth Scale Calibration.
3. Fence Stop Accuracy.
Schedule Maintenance
For optimum performance from your machine. follow
this maintenance schedule and refer to any specific
instructions given in this section.
Daily
- Vacuum all dust on and around the machine.
- Wipe down tables and all other unpainted cast iron
with a metal protectant.
Monthly Check
- V-Belt tension, damage or wear;
- Clean/vacuum dust buildup from inside cadinet and
off motor.
V-Belt
To ensure optimim power transmission from the motor
to the blade, the V-Belt must be in good condition
(free from cracks, fraying and wear) and propoerly
aligned and tensioned.
Cleaning
Cleaning the DE.1200/3 is relatively easy. Vacuum
excess wood chips and sawdust, and wipe off the
remaining dust with a dry cloth. If any resin has built
up, use a resin dissolving cleaner to remove it. Treat
all unpainted cast iron and steel with a non-staining
lubricant after cleaning.
Unpainted Cast Iron
Protect the unpainted cast iron surfaces on the table
by wiping the table clean after every use this ensures
moisture from wood dust does not remain on bare
metal surfaces. Keep tables rustfree with regular
applications.
Lubrication
Since all bearings are sealed and permanently
lubricated, simply leave them alone until they need to
be replaced. DO NOT lubricate them.
Table ways and the fence assembly should not
be lubricated. If the tables appear to be stuck,
disassemble and clean any foreign materials from the
ways. Re-assemble and reset the gibs.