MAKSIWA DE.1200/3, Инструкция по эксплуатации

Страница: 6 / 14

6
To install the carriage mounting bracket:
1. Align the locating pins on the back of the carriege
mounting bracket with the sockets on the jointer
table.
To install the fence carriage assembly:
1. Use two M8-1,25 x 20 cap screws, lock washers and
flat washers to secure the fence carriage assembly to
the carriage mounting bracket.
2. Use two M8-1,25 x 20 cap screws, lock washers and
flat washers to secure the fence assembly to the fence
carriage assembly.
3. Thread the fence tilting handles into the fence.
To install the cutterhead guard:
1. Wind the torsion spring knob back counterclockwise
a half turn and slide the guard shaft into the casting
shown in next figure. Make sure the slot on the
cutterhead guard shaft fits over the pin that sits inside
the spring knob barrel.
2. Test the guard by pulling it back and letting go.
2. Tighten the carriege mounting bracket to the
jointer table with the cap screws, lock washers and
flat washers.
Locating Pins
Sockets
Torsion Spring Knob