MAKSIWA DE.1200/3, Инструкция по эксплуатации

Страница: 13 / 14

13
Swing Stop
Jam Nut
Fence Stop Bolt
90° swing stop engaged.
90° swing stop engaged.
45° outward fence stop jam nut
Adjusting fence 45° outward.
2. Using a 90° square, adjust the fence to the 90°
position using the fence stop bolt and jam nut:
3. Loosen the jam nut on the 90° fence stop bolt.
4. Adjust the 90° fence stop bolt until it makes contact
with the 90° swing stop.
5. Retighten the jam nut loosened in Step 3 and
recheck.
To set the 45° outward fence stop:
1. Flip the 90° swing stop out of the way as shown in
next figure.
2. Using a sliding bevel adjusted to 135°, adjust the
fence to the 135° (45° outward) position.
3. Loosen the jam nut on the 45° outward fence stop
bolt.
4. Adjust the 45° outward fence stop bolt until it
makes contact with the back of the fence.
5. Retighten the jam nut loosened in Step 3 and
recheck.
Adjusting Gibs
The function of the table gibs is to eliminate excessive
play in the table movement. The gibs also control how
easy it will be to move the tables up and down.
To adjust the table gibs:
1. Using a 100mm wrench, loosen the two outfeed
table gib nuts on the side of the jointer base.
2. Using a 3mm hex wrench, evenly tighten the gib
stescrews a small amount, then check the table by
moving it up and down. Adjust the setscrews as needed
until the friction of the table movement is balanced
between minimal play and ease of movement.
NOTE : Tighter gibs reduce play but make it harder to
adjust the tables.
3. Repeat Steps 1-2 with the other table.
4. Set the outfeed table height as described in stting
Outfeed Table Height.
Swing Stop
Gib Setscrews
Gib Nuts