MAKSIWA CBC.EC, Инструкция по эксплуатации

Страница: 7 / 18

7
- Insert the cut piece of tape behind the aluminum
guide, between the guide and the Allen screws,
according to the same figure above.
- Push the guide against the tape, without forcing
much so that the tape does not bend.
- Tighten the screws. The distance of the guide is
already adjusted according to the thickness of the
tape.
- Do not remove the piece of tape.
- With a piece of wood, make sure the guide is aligned
with the glue axis. To make this movement push the
wood against the aluminum guides entry sliding to
contact the glue axis. The glue axis must move slightly
(right of 0.5 to 1 mm) so that, when operating, passes
the glue without hitting brusquely in the glue axis.
Just touch lightly, passing the glue on the panel.
TAPE PLACEMENT: To place your tape correctly,
follow these steps:
- Put the tape roll on the tape support previously
installed that already came with the machine.
- Insert the tape into the tape guide as shown in the
figure below, adjusting the knob A, so that the stops
only guide the tape at its height, without locking it.
Make sure, pulling and pushing the tape, you can
move freely.
- Position the tape to the zero point, in other words, at
the point where the wood touches the tape, taking it
with a little left over to be cutted.
- Your tape is regulated.
The operations made by the Edgebander CBC.E,
as well as any other machine, can pose risks to the
operator if the instructions in this section are not
taken into account.
These instructions are written with the understanding
that the operator has the knowledge and skills
necessary to operate this machine. If at any time you
feel difficulty performing any operation, stop using
the machine. If you are an inexperienced operator, we
recommend that you read books, technical papers, or
seeks training from an experienced operator before
performing any operation unknown. The machine
must operate with all the protections and security
systems that comes standard.
Above all, your safety must come first.
1. STARTING AND CONTROL
To turn on your CBC.E MAKSIWA proceed as follows:
- Connect the previously installed outlet at 110V single
phase supply.
- On the control panel you will find different commands.
Get to know each of them and their functions:
1. Turn the main switch ( 1 ). This key energizes the
machine’s panel, without turning it on.
2. Emergency Button ( 2 ) (red mushroom): When
triggered, instantly shuts down all machine controls.
To release it, just rotate clockwise.
machine, activates other commands and starts the
process of heating the glue. If the machine does not
turn on and the light does not turn on when you press
this button, make sure the main switch has been
turned on and the emergency button is not activated.
4. Off Button ( 4 ) (red): This button turns off the
machine by turning off all the functions, including
heating the glue.
5. Feeder Switch ( 5 ): This button activates the feeder
(rubber and glue axis). But this button will only be
released after the glue reaches the set temperature.
6. Temperature controller (6): It has two displays - the
upper display indicates the actual temperature of the
glue (red numbers) and the lower display shows the
OPERATIONS