MAKSIWA CBC.EC, Инструкция по эксплуатации

Страница: 6 / 18

6
ADJUSTMENTS
The following shown adjustments must be made
before using your Edgebander CBC.E for the first
time or when some kind of change is made as thick
tape or thickness of the wood.
CAUTION:
ANY ADJUSTMENT NEEDS TO BE MADE
WITH THE MACHINE OFF AND DE-ENERGIZED
(unplugged).
1. GLUE
The glue to be used in your Edgebander CBC.E
MAKSIWA is granulated glue type Hot Melt.
Always check the amount of glue on your machine.
Because of factory tests, their CBC.E can go with a
certain amount of glue.
If necessary insert adequate glue to the color of panel
wood and tape that you are using.
Do not put too much glue, because when it melt and
during operation of the machine may overflow and
cause leaks. Let also not miss glue in the glue pot
because this can cause failures in the collage.
WARNING:
TURN THE MACHINE IN 110V SINGLE
PHASE.
If will need a extension Cord, utilize a cable with 3
wires with 1,5mm² (or more).
ADJUSTMENTS
NOTE: The brand and quality of the glue is
fundamental. The MAKSIWA recommends glues that
work in the range of 160°C to 190°C. On top of that,
high temperature and melt glues can damage the
tape.
GLUE EXCHANGE: If you change the color of your tape
or the color of the wood panel, you may change the
glue on your Edgebander. To change the glue follow
these steps, but first read the rest of this manual to be
familiar with all operations:
- Turn on the machine and set the temperature
controller to 70°C (158°F) (see this manual to program
the controller).
- At this temperature, the glue is not too hot (soft)
or too cold (hard). So you can remove the entire glue
without much difficulty.
- Use a trowel or piece of wood, avoiding scrape the
walls of collared, damaging the same.
- After removing all the glue, put the new glue.
- Set the temperature controller according to the
specification of the glue again.
GLUE INDICATIONS: With this machine we
recommend the following glue brands:
• Artecola - 160ºC a 180ºC - Ivory-Color. Cod. 1820
White. Cod. 1821
• Durante Duditerm - 160ºC a 180ºC - White. Cod.
715/15
• Jowat - 150ºC a 180ºC - Ivory-Color. Cod. 282.20
White. Cod. 282.21
• Proadec - 160ºC a 180ºC - Ivory-Color. Cod. 5707
• Kleiberit - 150ºC a 180ºC - Ivory-Color. Cod. 788.3/20
White. Cod. 788.3/10
2. TAPE (EDGEBAND)
The Edgebander CBC.E MAKSIWA is designed to work
with PVC tape, ABS, paper and wood that do not have
glue, only straight parts. Use tapes approximately
4mm wider than the wood panel.
It is necessary to regulate the Edgebander according
to the thickness of the tape. That is, when changing
the thickness of the tape, it is necessary to adjust the
machine again. For this setting, follow these steps:
- Cut a piece of tape to be used.
- Loosen (without removing) the two screws shown in
the following figure, using a wrench 13: