![background image](http://html.mh-extra.com/html/makita/xrt02/xrt02_instruction-manual_1722988015.webp)
15 ENGLISH
Tying work
CAUTION:
Before inserting the battery car-
tridge, be sure to release your fingers from the
switch trigger and lock the trigger.
If you insert
the battery cartridge while the switch trigger is being
pulled, it may cause an accident if the wire tying
process is accidentally carried out.
CAUTION:
When you turn the power on, never
bring your limbs or face close to the binding or
rotating parts of the tool tip.
Otherwise, you may
be injured.
CAUTION:
When the power is turned on,
never touch the binding or rotating parts of the
tool tip.
Otherwise, you may be injured.
Fig.33
Preparation before work
1.
Make sure that the battery cartridge is removed
and the trigger is locked.
2.
Insert the battery cartridge into the tool, and turn
the power on. When you turn the power on, the wire is
cut automatically.
NOTICE:
Make sure that the tying mode lamp
lights up when the power is turned on. If it does
not light up, recharge the battery.
3.
Release the trigger lock.
1
2
3
4
Fig.34
►
1.
Trigger-lock button
2.
Switch trigger
3.
Power
button
4.
Tying mode lamp
Single actuation mode
1.
Push the arm firmly against the tying point. Make
sure to place the tool vertically over the rebars and
press the arm on the tying point at a 45° angle against
the crossed rebars.
45°
45°
1
Fig.35
►
1.
Arm
2.
Pull the switch trigger once.
3.
The wire is fed and cut automatically.
4.
The hook holds and twists the wire, then returns to
the original position after the wires have been tied.
Содержание XRT02
Страница 47: ...47 ...