![background image](http://html.mh-extra.com/html/makita/xrt02/xrt02_instruction-manual_1722988017.webp)
17 ENGLISH
4.
After tying, be careful not to hook the arm on the
rebars, and then pull the tool up.
Fig.40
Cautions on working
•
If you move the arm from the tying position during
the wire tying process, the wire will get stuck on
the hook, which may lead to incorrect tying.
•
Keep pressing the tool against the rebars until the
wire tying process is completed.
•
Do not move to the next tying point until the cur-
rent wire tying process is completed.
•
The tool tip rotating part (hook) twists the wire
during the wire tying process. Hold the grip firmly
so that your body is not pulled by the tool.
•
Do not touch the wires during the wire tying
process.
•
If you are repeating the wire tying processes in
the single actuation mode, fully release your finger
from the switch trigger. Then, continue to operate
the switch trigger.
•
If you pull the switch trigger when there is no tie
wire left, an error is displayed. Replace with a new
tie wire and restart the tool.
Tying tips
•
Tilt the tool at a 45° angle against the crossed
rebars, and tie the wire in alternate orientations as
shown in the figure.
Fig.41
•
Tie the wire onto the flat (with no unevenness)
sections of crossed rebars.
Fig.42
•
If tying strength is insufficient, change the tying
orientation and perform tying twice so that tying
strength increases.
Fig.43
NOTICE:
When you make the second tie, bend
the tail of the first tie before making the second
tie.
Otherwise, the wire may be repelled a second
time. It may cling to the tool tip, and the hook may be
damaged.
Replacing the tie wires
CAUTION:
When you replace the wire, be sure
to turn the power off, lock the trigger, and remove
the battery cartridge.
Failure to do so may cause an
accident.
1.
When wire has been used up, an error tone will
sound and error "1" will be displayed.
2.
Lock the trigger, turn the power off, and remove
the battery cartridge.
Содержание XRT02
Страница 47: ...47 ...