14 ENGLISH
•
Avoid strumous sections of rebars.
•
If tying strength is insufficient, change the tying orientation
and perform tying twice so that tying strength increases.
NOTICE:
When you make the second tie, bend
the tail of the first tie before making the second tie.
Otherwise, the wire may be repelled a second time. It
may cling to the tool tip, and the hook may be damaged.
Replacing the tie wires
CAUTION:
When you replace the wire, be sure
to turn the power off, lock the trigger, and remove the
battery cartridge.
Failure to do so may cause an accident.
1.
When wire has been used up, an error tone will
sound and error "1" will be displayed.
2.
Lock the trigger, turn the power off, and remove
the battery cartridge.
3.
Push the release lever, and lock it with the lock lever.
1
2
►
1.
Release lever
2.
Lock lever
4.
Remove the wire reel from the tool.
NOTE:
When wire has been used up normally,
approximately 20 cm (8") of the wire remains wound
on the reel. In this state, replace the wire reel with a
new one.
If it is difficult to remove the wire reel from the tool,
follow the steps below.
1.
Insert the battery cartridge into the tool, and
turn the power on. The tool feeds the wire and cuts it
automatically.
2.
Lock the trigger, turn the power off, and remove
the battery cartridge.
3.
Remove the wire breaks using tools such as nip-
pers or pliers.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Storage of the hex wrench
Store the hex wrench in the position shown in the figure.
1
►
1.
Hex wrench