15 ENGLISH
Cleaning the cutter
When the tool is used for a long period of time, dust and
wire particles may become adhered to the cutter sec-
tion. In such a case, disassemble and clean the cutter
according to the following procedure.
If a wire is caught in the cutter section, the wire can be
removed by following the same procedure.
Disassembling and cleaning
1.
Loosen bolts A and B using the hex wrench
included in the tool package.
1
3
4
2
►
1.
Bolt A
2.
Bolt B
3.
Contact plate cover
4.
Wire
guide B
NOTICE:
Do not forcibly remove any bolts that
cannot be removed using the hex wrench.
2.
Pull the contact plate cover up in the direction of
the arrow and remove it. Bolt B will be removed at the
same time.
2
1
►
1.
Contact plate cover
2.
Bolt B
3.
Remove bolt A, and remove wire guide B.
1
2
►
1.
Bolt A
2.
Wire guide B
4.
Turn wire guide B over and clean its inside.
5.
Remove cutter A, cutter B, top plate, and link arm
A from arm plate A. Then, clean them.
1
5
4
2
3
►
1.
Cutter B
2.
Link arm A
3.
Cutter A
4.
Arm plate A
5.
Top plate
