5
29.
Always be sure you have a firm footing. Be
sure no one is below when using the tool in
high locations.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
USD201-2
Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
hertz
･
alternating
current
･
no
load
speed
･
Class II Construction
･
revolutions or reciprocation per minute
FUNCTIONAL DESCRIPTION
WARNING:
•
Always be sure that the tool is switched off
and unplugged before adjusting or checking
function on the tool.
Failure to switch off and
unplug the tool may result in serious personal
injury from accidental start-up.
Switch action
1
013899
CAUTION:
•
Before plugging in the tool, always check to see
that the tool is switched off.
To start the tool, slide the slide switch toward the "I
(ON)" position.
To stop the tool, slide the slide switch toward the "O
(OFF)" position.
Adjusting the orbital stroke rate
1
012852
The orbital stroke rate is adjustable. To change the
orbital stroke rate, turn the dial between 1 and 5. The
higher the number is, the higher the orbital stroke rate is.
Preset the dial to the number suitable for your
workpiece.
NOTE:
•
The dial cannot be turned directly from 1 to 5 or
from 5 to 1. Forcing the dial may damage the tool.
When changing the dial direction, always turn the
dial moving it through each intermediate number.
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the orbital stroke
rate is kept constant even under load condition.
1. Dial
1. Slide switch
