![background image](http://html.mh-extra.com/html/makita/ls711d/ls711d_instruction-manual_224112029.webp)
29
(2) 45
°
bevel angle
Adjust the 45
°
bevel angle only after performing 0
°
bevel angle adjustment. To adjust left 45
°
bevel
angle, loosen the lever and tilt the blade to the left
fully. Make sure that the pointer on the arm points to
45
°
on the bevel scale on the arm holder. If the
pointer does not point to 45
°
, turn the 45
°
bevel
angle adjusting bolt (upper bolt) on the right side of
the arm until the pointer points to 45
°
.
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take out
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
After replacing brushes, insert the battery cartridge into the
tool and break in brushes by running tool with no load for
about 1 minute. Then check the tool while running and elec-
tric brake operation when releasing the switch trigger. If elec-
tric brake is not working well, ask your local Makita service
center for repair.
After use
•
After use, wipe off chips and dust adhering to the tool
with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
section titled “Blade guard”. Lubricate the sliding
portions with machine oil to prevent rust.
•
When storing the tool, pull the carriage toward you fully
so that the slide pole is thoroughly inserted into the turn
base.
1. 45
°
bevel angle adjusting bolt
1
002250
1. Limit mark
1
001145
1. Screwdriver
2. Brush holder cap
1
2
002222
Содержание LS711D
Страница 32: ...Memo 32 ...