![background image](http://html.mh-extra.com/html/makita/ls711d/ls711d_instruction-manual_224112012.webp)
12
Maintaining maximum cutting capacity
This tool is factory adjusted to provide the maximum cutting
capacity for a 190 mm (7 - 1/2”) saw blade.
When installing a new blade, always check the lower limit
position of the blade and if necessary, adjust it as follows:
First, remove the battery cartridge. Push the carriage toward
the guide fence fully and lower the handle completely. Use
the socket wrench to turn the adjusting bolt until the periph-
ery of the blade extends slightly below the top surface of the
turn base at the point where the front face of the guide fence
meets the top surface of the turn base.
With the battery cartridge removed, rotate the blade by hand
while holding the handle all the way down to be sure that the
blade does not contact any part of the lower base. Re-adjust
slightly, if necessary.
CAUTION:
•
After installing a new blade, always be sure that the
blade does not contact any part of the lower base when
the handle is lowered completely. Always do this with the
battery cartridge removed.
Stopper arm
The lower limit position of the blade can be easily adjusted
with the stopper arm. To adjust it, move the stopper arm in
the direction of the arrow as shown in the figure. Adjust the
adjusting screw so that the blade stops at the desired posi-
tion when lowering the handle fully.
1. Adjusting bolt
2. Guide fence
3. Turn Base
1. Top surface ot turn base
2. Periphery of blade
3. Guide fence
1
2
3
002196
2
1
3
001540
1. Adjusting screw
2. Stopper arm
1
2
002241
Содержание LS711D
Страница 32: ...Memo 32 ...