Makita LH1040F, Инструкция по эксплуатации

Страница: 16 / 24

16
CAUTION:
•
Never attempt to cut thick or round aluminum
extrusions. Thick aluminum extrusions may come
loose during operation and round aluminum
extrusions cannot be secured firmly with this tool.
•
Never cut aluminum in the table saw mode (bench
mode).
6. Wood facing
Use of wood facing helps to assure splinter-free
cuts in workpieces. Attach a wood facing to the
guide fence using the holes in the guide fence.
See the figure concerning the dimensions for a
suggested wood facing.
Over 10mm
1
Over 460mm
90mm 107mm 107mm 90mm
1
90mm
25mm
005577
CAUTION:
•
Use straight wood of even thickness as the wood
facing.
•
Use screws to attach the wood facing to the guide
fence. The screws should be installed so that the screw
heads are below the surface of the wood facing.
•
When the wood facing is attached, do not turn the
turn base with the handle lowered. The blade
and/or the wood facing will be damaged.
7. Cutting repetitive lengths
1
2
3
012657
When cutting several pieces of stock to the same
length, ranging from 240 mm to 400 mm, use of the
set plate will facilitate more efficient operation.
Install the set plate on the holder as shown in the
figure.
Align the cutting line on your workpiece with either
the left or right side of the groove in the kerf board,
and while holding the workpiece from moving,
move the set plate flush against the end of the
workpiece. Then secure the set plate with the screw.
When the set plate is not used, loosen the screw
and turn the set plate out of the way.
NOTE:
•
Use of the holder-rod assembly (optional
accessory) allows cutting repetitive lengths up to
2,200 mm approximately.
CUTTING AS TABLE SAW (BENCH MODE)
CAUTION:
•
(For tools for European countries) when using the
tool in the table saw mode (bench mode), flip the
sub-fence outward and then take the following
procedures.
When using the tool in the table saw mode (bench mode),
(in case of tools for European countries, flip the
sub-fence outward and) place the blade cover on the turn
table so that the blade cover is centered over the slit for
the blade entrance in the turn table and two small bosses
on the underside of the blade cover fit into the
semi-circular slit in the periphery of the turn table as
shown in the figure and then lock the handle in the lowest
position by fully pushing in the stopper pin. If not fixing
the blade cover, the table can not be down.
1
2
015244
CAUTION:
•
Always use "work helpers" such as push sticks and
push blocks when there is a danger that your hands
or fingers will come close to the blade.
•
Always hold the workpiece firmly with the table and
the rip fence. Do not bend or twist it while feeding. If
the workpiece is bent or twisted, dangerous
kickbacks may occur.
•
NEVER withdraw the workpiece while the blade is
running. If you must withdraw the workpiece before
completing a cut, first switch the tool off while
holding the workpiece firmly. Wait until the blade
has come to a complete stop before withdrawing
the workpiece. Failure to do so may cause
dangerous kickbacks.
•
NEVER remove cut-off material while the blade is
running.
•
NEVER place your hands or fingers in the path of
the saw blade.
1. Blade cover
2. Small boss
1. Set plate
2. Holder
3. Screw
1. Hole