Makita LH1040F, Инструкция по эксплуатации

Страница: 11 / 24

11
Adjusting riving knife
1
2
3
4-5mm
005549
Before adjusting the riving knife, loosen the two levers by
turning counterclockwise and press the top table on the
right side nearby the riving knife to its lowered position.
Then secure the top table by firmly re-tightening the two
levers as shown in the figure.
There must be a clearance of about 4 - 5 mm between the
riving knife and the blade teeth. Adjust the riving knife
accordingly by loosening two hex bolts counterclockwise
with the hex socket wrench and measuring the distance.
Tighten the hex bolts securely, and then check to see that
the top blade guard works smoothly before cutting.
1
015241
The riving knife has been installed before shipment from the
factory so that the blade and riving knife are in a straight line.
2
1
3
005551
CAUTION:
•
If the blade and riving knife are not aligned properly, a
dangerous pinching condition may result during
operation. Make sure the riving knife is positioned
between both outer ends of the blade teeth when
viewing from the top. You could suffer serious personal
injury while using the tool without a properly aligned
riving knife. If they are not aligned for any reasons,
always have Makita authorized service center repair it.
•
Don't remove the riving knife.
Installing and adjusting rip fence
1
2
5
3
4
005553
1. Install the rip fence on the table so that the rip fence
holder engages with the guide rail. Tighten the
clamping screw (B) of the rip fence firmly clockwise.
2. Loosen the clamping screw (A).
3. Slide the rip fence and secure it so that the far end from
you of the rip fence is aligned with the point at which the
front edge of saw blade just appears from top surface of
the workpiece. The purpose of this adjustment is to
reduce risk of kick-back toward operator that cut piece
from the workpiece is pinched between the saw blade
and rip fence and finally pushed out toward operator.
The line 3 varies by thickness of workpiece or the table
level. Adjust the position of the rip fence according to the
thickness of the workpiece.
After adjusting the rip fence, tighten the clamping
screw (A) firmly.
5
4 3
1
2
6
005554
NOTE:
•
There are four patterns to position the rip fence as
shown in the figure. Rip fence has two slits on its
sides, one slit with an elevated fringe nearby on the
same side and the other without it. Use the surface of
rip fence with this fringe facing the workpiece only
when cutting off into a piece of a thin workpiece.
2
1
3
A B C D
005555
1. Hex bolts
1. Rip fence
2. Rip fence holder
3. Saw blade
1. Rip fence
2. Rip fence holder
3. Line to be
aligned with
4. Saw blade
5. Top table
6. Workpiece
1. Rip fence holder
2. Guide rail on the
top table
3. Clamping screw
(A)
4. Clamping screw
(B)
5. Rip fence
1. Blade width
2. Riving knife
3. Hex bolt
1. Top blade guard
2. Riving knife
3. Area to press in