Makita LH1040F, Инструкция по эксплуатации

Страница: 10 / 24

10
1
012646
To remove the blade, first loosen the clamping screw so that
the lower blade guard B is lowered as shown in the figure.
5
4
6
1
2
3
012647
Then use the socket wrench to loosen the hex bolt
holding the center cover by turning it counterclockwise.
Raise the lower blade guard A and center cover while
pushing the lever nearby the handle to the left.
3
2
1
4
005545
Press the shaft lock to lock the spindle, use the socket
wrench to loosen the hex bolt clockwise. Then remove
the hex bolt, outer flange and blade.
3
1
2
005544
To install the blade, mount it carefully onto the spindle,
making sure that the direction of the arrow on the surface of
the blade matches the direction of the arrow on the blade
case. Install the outer flange and hex bolt, and then use the
socket wrench to tighten the hex bolt (left-handed) securely
counterclockwise while pressing the shaft lock.
2
1
2
1
005546
2
1
3
4
005547
NOTE:
•
When installing a saw blade, be sure to insert it
from the outside of the blade guard B at first and
then raise it so that the blade is finally placed in the
blade guard B.
1
2
3
4
6
5
005548
CAUTION:
•
The ring 25.0 mm or 30 mm in outer diameter is
factory-installed onto the spindle. Before mounting
the blade onto the spindle, always be sure that the
correct ring for the arbor hole of the blade you
intend to use is installed onto the spindle.
Return the lower blade guard A and center cover to its
original position. Then tighten the hex bolt clockwise to
secure the center cover. Raise the blade guard B as far
as it will go and tighten the clamping screw firmly while
holding it in the raised position. Lower the handle to
make sure that the lower blade guards move properly.
Make sure shaft lock has released spindle before making
cut.
1. Hex bolt
2. Outer flange
3. Saw blade
4. Inner flange
5. Spindle
6. Ring
1. Blade case
2. Arrow
3. Saw blade
4. Arrow
1. Saw blade
2. Blade guard B
1. Socket wrench
2. Shaft lock
3. Hex. bolt
1. Center cover
2. Socket wrench
3. Hex bolt
4. Blade guard A
1. Lower blade
guard A
2. Lower blade
guard B
3. Clamping screw
4. Top table
5. Motor housing
6. Handle
1. Stopper pin