Makita LH1040F, Инструкция по эксплуатации

Страница: 13 / 24

13
1
2
005560
If you connect a vacuum cleaner to your saw, more
efficient and cleaner operations can be performed.
1
3
2
005561
To install the blade cover when using in the table saw
mode (bench mode), turn the turn base to 0° miter angle
(see the section titled "Adjusting miter angle") and place
the blade cover on the turn table so that the blade cover
is centered over the slit for the blade entrance in the turn
table and then lock the handle in the lowest position by
fully pushing in the stopper pin as shown in the figure.
NOTE:
•
To attach the dust bag to the front dust nozzle in the
table saw mode (bench mode), first remove the cap
from the front dust nozzle and then attach the dust
bag to the dust nozzle.
•
When not in use of dust bag, always replace the
cap to the front dust nozzle. Failure to do so result
in dust scattering from the nozzle.
•
When using the tool in the table saw mode (bench
mode), make sure that the blade cover is installed
on the turn table.
Securing workpiece
Whenever possible, secure the workpiece with the
optional vise. If you must use your hand to hold the
workpiece, then it must be done firmly and securely so as
not to lose control of the workpiece. Your hand and arm
must be kept well away from the blade area (100 mm
minimum). Squeeze the workpiece firmly against the
guide fence with your fingers held over the top of the guide
fence. The workpiece must also rest steadily on the turn
base.
WARNING:
•
Never use your hand to hold the workpiece that
requires your hand to be any closer than 100 mm
from the blade area. In this case, always use the
optional vise to secure the workpiece. After any
cutting operation, raise the blade gently. Never
raise the blade until it has come to a complete stop.
Serious injury may result.
CAUTION:
•
When cutting long workpieces, use supports that
are as high as the top surface level of the turn base.
Do not rely solely on the vertical vise and/or
horizontal vise (both optional) to secure the
workpiece.
Thin material tends to sag. Support workpiece over
its entire length to avoid blade pinch and possible
KICKBACK.
1
2
001549
Sub-fence (for European countries only)
1
015243
This tool is equipped with the sub-fence. Usually position
the sub-fence inside. However, when performing left
bevel cuts, flip it outward.
CAUTION:
•
When performing left bevel cuts, flip the sub-fence
outward. Otherwise, it will contact the blade or a
part of the tool, causing possible serious injury to
the operator.
1. Sub-fence
1. Support
2. Turn base
1. Vacuum cleaner
2. Dust bag
3. Blade cover
1. Dust bag
2. Fastener