Makita JS8000, Инструкция по эксплуатации

Страница: 5 / 32

5
When using the hook, pull it out in ''A'' direction and then
push it in ''B'' direction to secure in place.
When not using the hook, return it back to its initial
position by following the above procedures in reverse.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Replacement of blades
CAUTION:
• Never remove the blades with bare hands. Wear
gloves. Otherwise it can cause injury.
Removing cutting head (Fig. 4)
Use the hex wrench to loosen the three screws which
secure the cutting head. Pull the cutting head straight out
to remove it with turning it left and right alternately.
Removing shear blades (Fig. 5)
Remove the two screws (middle and front) which hold the
cutting head. When removing the middle screw, be careful
not to lose the spacer. Then the blades can be removed
easily. When removing the blades, hold the blades, the
spacer and the pivot sleeve so that they do not fall from
the cutting head.
Installing shear blades (Fig. 6)
Install the spacer and the pivot sleeve and tighten the
three screws after inserting the center blade, side blades
into the cutting head. In this process, the screw heads
should be protruding 2 - 3 mm from the cutting head
surface.
If you will tighten the screws excessively, the cutting head
cannot be installed to the tool.
NOTE:
• Side blade edge can be used in four ways by
repositioning them left-to-right and end-to-end as
shown in the figure.
(Fig. 7)
The following describes time and procedure to change
blades.
A) When the two side blades have rounded about half
their width, they can be repositioned left-to-right for
new cutting edges.
B) When both edges of each side blade have rounded
about half their width, reposition them end-to-end for
two new cutting edges.
C) When all edges have worn down, obtain replacements
from Makita authorized or factory service center.
D) When side blades are worn out, the center blade
should also be replaced.
Installing cutting head (Fig. 8)
CAUTION:
• Secure the cutting head firmly. Otherwise it can rotate
during operation and can cause serious injury.
Insert the cutting head into the tool with turning it left and
right alternately. Then tighten the three screws with the
hex wrench.
OPERATION
CAUTION:
• This tool is intended for cutting fiber cement material
only, with a thickness of 8 mm or less. Do not cut other
materials or stack-cut. Doing so will damage the tool
and void warranty.
• Wear gloves. Otherwise it can cause injury.
Secure the workpiece firmly. Move the tool forward
keeping the side blades flush with the workpiece surface.
(Fig. 9)
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
Lubrication (Fig. 6)
Before operation, lubricate the contact point of the center
blade and the side blades. And, also lubricate around the
pivot sleeve and the spacer.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Center blade
• Side blades
• Hex wrench