P 1
0
/ 2
4
[3] DISASSEMBLY/ASSEMBLY
[3] -3. Cylinder Section
R
epair
DISASSEMBLY
1) HR3200C, HR3210C: Disassemble Chuck section. (Figs. 5 and 6)
HR3210FCT: Disassemble Tool holder assembly. (Figs. 5 and 7)
2) After removing Crank housing cover, disassemble Barrel complete, and separate Tool holder section from Barrel
complete. (Fig. 13)
3) Separate Tool holder section (Tool holder guide section) from Cylinder section. (Figs. 14 and 14A)
4) The parts on Cylinder 25 can be removed as illustrated in Fig. 18.
5) Disassemble Rubber ring 13 and Slide plate from the inside of Cylinder 25 as illustrated in Fig. 19.
O ring 26
Driving sleeve
Lock sleeve
Flat washer 40
Ring 29
Slide
sleeve
Compression
spring 34
Cylinder 25
Compression
spring 42
Fig. 18
Fig. 19
Rubber ring 13
Remove Rubber ring 13.
Slide plate
Now Slide plate is removed
from Cylinder 25.
Align Slide plate with the
elliptic hole of Cylinder 25
by turning approx. 90 degree.
ASSEMBLY
1) Take the reverse of the disassembling steps. Refer to Figs. 19 and 18.
Join the assembled Cylinder section to Tool holder (Tool holder guide section) with Pin 6.
Refer to Figs. 14 and 14A.
Note: When inserting Rubber ring 13 into Cylinder 25, face the steel portion of Rubber ring 13 to Tool holder (Tool holder
guide) side as illustrated in Fig. 19.
Impact bolt
Rubber portion
of Rubber ring 13
Cylinder 25
Slide plate
Steel portion
of Rubber ring 13
Tool holder
(Tool holder guide)
Fig. 20
