![background image](http://html2.mh-extra.com/html/makita/hm1205c/hm1205c_technical-information_4152913017.webp)
P 17/ 17
Fig. D-3
Wiring in Handle
Wiring to Switch
Fix Lead wires with
Sponge sheet and
Lead wire holder.
Connect the insulated connectors so that
the clamped portions are set inside the
width of Switch as shown below.
If the clamped portions of insulated connectors
are out of the width of Switch, they interfere with
installing Switch.
Connector
for connecting
to Controller
Lead wire holder
Terminal block
Lead wire holder
covered with Sponge
sheet
Switch
Switch
The following Lead wires have to be
routed over Lead wire (thin, black)
and to be routed through Lead wire holder.
* Lead wire (thick, black) connected to
Switch and Terminal block
* Lead wire (thick, white) connected to
Switch and Controller
Insulated connectors
Fig. D-4
The clamped
portions
The clamped
portions
the width of
Switch
the width of
Switch
Route Lead wires through
these lead wire holders.
Lead wires must be tightened
in this position.
W
iring diagram
Switch