![background image](http://html2.mh-extra.com/html/makita/hm1205c/hm1205c_technical-information_4152913007.webp)
P 7/ 17
R
epair
[3] ASSEMBLY/ DISASSEMBLY
[3] -2. Impact bolt, Cylinder, Striker (cont.)
Shoulder
sleeve
Shoulder
sleeve
Impact bolt
(3) Mount Shoulder sleeves and Rubber ring 24 to Impact bolt as drawn in
Fig. 13
.
(4) Assemble components by reversing the disassembly steps (3) to (1). (Refer to
Figs. 9
and
7
.)
Note:
Be careful of the directions of Shoulder sleeves.
See the drawings below.
Rubber
ring 24
Fig. 13
Cylinder 40
Striker
Crank housing side
Impact bolt side
(1) Insert Striker with O ring 31.5 into Cylinder 40 so that O ring 31.5 faces to Crank housing side as drawn in
Fig. 10
.
(2) Assemble X ring 21, O ring 23 and Fluoride ring 28 to Impact bolt as drawn in
Fig. 12.
Note:
1) If Fluoride ring 28 is worn, O ring 23 (orange) appears through Fluoride ring 28 on Impact bolt.
If so, be sure to replace O ring 23 together with Fluoride ring 28 and X ring 21 with new ones.
2) If there is dust in Tool holder, wash it off.
3) Once Fluoride ring 28 deforms, it does not shrink by itself. If installing it into Impact bolt
without the proper step, it may result in its breakage. So insert Impact bolt into Taper Sleeve (1R214)
for about 60 seconds to fit Fluoride ring 28 into the groove on Impact bolt.
One way
valve guide
O ring 31.5
Cylinder 40
Fig. 10
Fig. 11
Correct
Wrong
Taper sleeve
(No.1R214)
Insert Impact bolt into
the
HR5001C side
of
Taper Sleeve. And keep
it
approx. 60 seconds
in Taper sleeve.
Impact bolt
Assemble of Rings to Impact bolt
Before Correction:
Rings' edges are protruding from
the top edge of the groove on
Impact bolt.
groove on Impact bolt
Fluoride ring 28
X ring 21
O ring 23
After Correction:
Rings' edges are positioned
under the top edge of the
groove on Impact bolt.
Corrected
Fig. 12
O ring 31.5
ASSEMBLING
One way
valve guide
Striker
Crank housing side
Impact bolt side