P
8
/ 1
0
R
epair
ASSEMBLING
(8) Assemble Base to the machine. Refer to
Fig. 1
.
Note
: Do not forget to mount Flat washers and Spring washers between Base and M8x16 Hex bolt.
Rubber foot
Base
Assemble Rubber foot to Base with M6x15 Hex bolt, Flat washer, Spring washer and M6 Hex nut.
Note
: Tighten M6x15 hex bolt to
2.5 ~ 3.5 N.m
fastening torque.
Flat washer
Spring washer
M6x15 Hex bolt
Fig. 12
(7) Assemble Base as drawn in
Fig. 12
,
and check the condition of Impeller, in case of replacing the Engine to the new one.
[3] DISASSEMBLY/ASSEMBLY OF PUMP SECTION
[3] -1. Pump Section (cont.)
In case of replacing the Engine to the new one
1. Make sure that the fuel is removed completely from the Engine.
2. Switch off.
3. Pull Recoil starter in order to make sure that the rotating Impeller does not touch Volute.
In case of touching Volute, return to
Fig. 8
, and adjust by adding or reducing Washer(s).
