1R364
a set of M6 bolts
(components of 1R364)
[4] DISASSEMBLY/ASSEMBLY
[4]-8. Flywheel
ASSEMBLING
Insert Woodruff key 3 in the groove on Crankshaft and
mount Flywheel, then tighten Flywheel with M8 Flange nut clockwise.
Note: Wipe off grease and oil on Crankshaft to fit Flywheel tightly.
Fig. 20
DISASSEMBLING
Flange nut
(M8)
Woodruff key 3
Key groove of
Flywheel’s hole
R
epair
P
8
/ 1
4
Fig. 21
Remove M8 Flange nut and pull out Fly wheel with 1R364. (
Fig. 20
)
1. Remove M8 Flange nut by turning it counterclockwise
using Cordless impact driver with 13mm Socket bit.
Note:
•
M8 Flange nut can be loosen easily with Impact
driver without locking Piston.
•
Do not remove Spark plug because compressed
air resistance in Cylinder is used for Piston locking.
• Remove
Plug cap to prevent accidental engine start.
2. Set 1R364 by screwing a set of M6 bolts to
Flywheel equally, and pull out Flywheel
from Crankshaft by turning center bolt of
1R364 clockwise.
Center bolt
Crankshaft
Assemble Flywheel to Crankshaft by following the procedure in
Fig. 21
.
