CAUTION: Repair the machine in accordance with “Instruction manual” or “Safety instructions”.
[2] HANDLING OF GASKET
R
epair
P
2
/ 1
8
[1] NECESSARY REPAIRING TOOLS
Description
Code No.
Use for
Once Gasket is removed:
(1) Clean up the mating surface where the gasket was installed to maintain its sealing performance.
(2) Replace it with a new one.
Retaining ring pliers ST-2 for External ring
1R004
press-fitting Spindle complete with Ball bearing 609ZZ and
Retaining ring S-9 into Pipe holder
Bearing setting pipe 23-15.2
1R029
press-fitting Spiral bevel gear 12 with two Ball bearing 6000ZZ
into Gear housing complete
Bearing setting pipe 25-17.2
1R030
removing/ installing Retaining rings S-12 and S-24
Retaining ring pliers ST-2N
1R003
removing Spiral bevel gear 9
Retaining ring pliers RT-2N for Internal ring
1R005
removing/ installing Retaining ring R-22
removing Ball bearing 6000DDU from Cutter shaft complete
Bearing setting plate 10.2
1R033
removing Ball bearings
Gear extractor (Large)
1R045
Air density tester
1R127
diagnosing Carburetor
Drill chuck extractor
1R139
removing Cam A from Spiral bevel gear 9
Ring 22
1R217
Round bar for arbor 20-100
1R247
removing Spindle complete with Ball bearing 609ZZ and
Retaining ring S-9 from Pipe holder
Round bar for arbor 7-100
1R236
removing Spiral bevel gear 12 from Gear housing complete
Bearing extractor (small)
1R269
removing Ball bearings
Round bar for arbor 6-50
1R286
removing Clutch drum from Clutch case
Round bar for arbor 6-50
1R280
removing Cam A from Spiral bevel gear 9
Retaining ring S and R pliers
1R291
removing/ installing Retaining rings
Flywheel puller
1R364
removing Flywheel
Feeler gauge set
1R366
adjusting Ignition coil, Spark plug
Wrench 4 (Standard equipment)
783223-2
782233-6
removing/ installing M5x6 Hex socket hex bolt
Box driver 10-16 (Standard equipment)
removing/ installing M6-10 Hex lock nut
Wire brush
---
cleaning Spark plug
