15 / 71
Fig. 31
5
Hook Starter rope [1] on the U-shaped notch of Reel
[2], and then turn Reel [2] counterclockwise at least
three turns to increase the tension on Spiral spring.
Note
Do not turn Reel [2] clockwise or Spiral spring will be
deformed.
6
Unhook Starter rope from the U-shaped notch to let Reel wind up Starter rope into Recoil starter.
Fig. 32
7
Make sure that Starter rope [1] is wound up with an
optimum tension.
Note
Starter knob [2] should get upright by itself if you let go
of it, and Reel should turn approximately one more turn
even after Starter rope [1] is pulled to the full.
Fig. 33
8
Check Swing arms for correct operation.
They should be raised when you pull Starter knob [1],
and should be lowered down back to the initial position
when you release Starter knob [1].
[1]
[1]
[1]
[2]
[1]
[2]
