Makita EA3500S, Руководство оператора и по безопасности

Страница: 39 / 44

39
Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be
performed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform
the prescribed maintenance work can lead to accidents!
The user of the chain saw must not perform maintenance work which is not described in the instruction manual. All such work must
be carried out by a MAKITA service center.
Page
General Chain saw Clean exterior, check for damage. In case of damage, have
repaired by a qualified service center immediately
Saw chain Sharpen regularly, replace in good time 31
Chain brake Have inspected regularly at an authorized service center
Guide bar Turn over to ensure even wear of bearing surfaces
Replace in good time
20, 22, 25
Starter cable Check for damage. Replace if damaged. 37
Before each start
Saw chain Inspect for damage and sharpness 31
Check chain tension 20, 22, 25
Guide bar Check for damage
Chain lubrication Functional check 28
Chain brake Functional check 30
Combination switch,
Safety locking button,
Throttle lever
Functional check 29
Fuel/oil tank cap Check for tightness and lekages
Every day Air filter Clean (several times daily if necessary) 35
Guide bar Check for damage, clean oil intake bore 33
Guide bar support Clean, in particular the oil guide groove 28, 33
Idle speed Check (chain must not run) 30
Every week Fan housing Clean to maintain good cooling air flow. 16
Air filter compartment Clean to maintain good cooling air flow. 38
Fan compartment Clean to maintain good cooling air flow. 38
Cylinder fins Clean to maintain good cooling air flow. 38
Spark plug Check and replace if necessary 36
Muffler Check tightness of mounting, Check screws 16, 36
Chain guide Check
Screws and nuts Check their condition and that they are firmly secured.
Spark arrester screen Clean and replace if necessary 38
Every 3 months Fuel filter Replace 38
Fuel, oil tanks Clean
Annually Chain saw Check at an authorized service center
Storage Chain saw Clean exterior, check for damage. In case of damage, have
repaired by a qualified service center immediately
Guide bar/chain Demount, clean and oil slightly
Clean the guide groove of the guide bar 33
Fuel, oil tanks Empty and clean
Carburetor Run empty