Fig. 5-2-1-4
[5] Twist Sleeve while pulling it up toward the blade install
side to set it in release position.
Fig. 5-2-1-5
[6] While holding the top of Slider by finger, push out Pin 3
with a thin bar.
Note:
Without holding Slider, Push plate will pop out from
the slit of Slider.
Sleeve
Pull
Sleeve in Lock
position
Sleeve in release
position
Pin 3
Slider
Pull out
Fig. 5-2-1-6
[7] Remove Sleeve, Push plate, Compression spring 2 and Torsion spring 17. (Compression spring 2 is in the groove on Slider.)
Groove on
Slider
Torsion spring 17
Compression spring 2
Push plate
Sleeve
Fig. 5-2-1-7
[8] The components of Slider assembly are as follows:
Compression spring 2
Torsion
spring 17
Pin 3
Sleeve
Shoulder pin 5
Compression
spring 6
Driving sleeve
Retaining ring (EXT) 18
Protector
Pin 3
Guide sleeve
Driving
sleeve guide
Push plate
8 / 24
