7 ENGLISH
Sighting
1
B
A
►
1.
Cutting line
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the
B position with it.
Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
CAUTION:
Do not pull the switch trigger
hard without pressing the lock-off lever. This can
cause switch breakage.
1
2
►
1.
Lock-off lever
2.
Switch trigger
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool, slide
the lock-off lever and pull the switch trigger. Release the
switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing diamond
wheel
CAUTION:
Use only the Makita wrench to
install or remove the diamond wheel.
CAUTION:
When installing the diamond
wheel, be sure to tighten the bolt securely.
CAUTION:
Always install the diamond wheel
so that the arrow on the diamond wheel points in
the same direction as the arrow on the diamond
wheel case.
Otherwise the wheel rotates in reverse,
it may cause personal injury.
1
2
3
4
►
1.
Shaft lock
2.
Hex wrench
3.
Tighten
4.
Loosen
1
2
3
4
5
►
1.
Hex bolt
2.
Outer flange
3.
Diamond wheel
4.
Inner flange
5.
Arrow
To remove the diamond wheel, press the shaft lock fully
so that the diamond wheel cannot revolve and use the
hex wrench to loosen the hex bolt counterclockwise.
Then remove the hex bolt, outer flange and diamond
wheel.
To install the diamond wheel, follow the removal pro
-
cedure in reverse. Make sure the diamond wheel is
installed so that the arrow on the wheel points in the
same direction as the arrow on the diamond wheel
case.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
