MAKINEX MS-150, Руководство оператора

Страница: 11 / 18

MAKINEX MS-150
Operator’s Manual Rev1222
Page 9 of 15
13. Switch Mixer
back ‘ON’ and return to Maximum Power until Levelling Compound is mixed
to a lump-free consistency.
14. Once equal consistency has been achieved, turn off the Makinex Electric Mixer.
15. Unplug Makinex Electric Mixer from extension cord; wind-up the Power Cord on the MS-
150 Handle.
STEP 3
– POURING AND PLACING LEVELLING COMPOUND
CAUTION
ALWAYS check that power cord is secured around the MS-150 handle
before pivoting the bucket.
CAUTION
NEVER
place hand near the ‘Pivot Pin’ (Pivot Point) when rotating the
bucket.
CAUTION
NEVER move or operate the fully loaded MS-150 over an unstable surface.
CAUTION
ALWAYS protect open drains nearby from spillages of compound
1. Lift and remove the Vac Lid Module in a sideways direction with extension cord, vac hose
and water hose still connected and place nearby. The Vac Lid Module is released from the
Bucket by unclipping the Side Hooks.
2. Check the
‘Locking Pin’ is engaged (i.e., locked to prevent the bucket from pivoting) at the
base of the bucket.
3. Disengage castor wheel brake.
4. Wheel the MS-150 to the desired area (use caution when moving the loaded bucket).
5. Disengage (unlock)
‘Locking Pin’ at the base of the bucket.
Vac Lid Module with vac
hose, extension cord
and water hose attached
Side Hooks