MAKINEX MS-150, Руководство оператора

Страница: 10 / 18

MAKINEX MS-150
Operator’s Manual Rev0322
Page 8 of 15
5. Add in correct amount of water for desired mix quality (refer to Levelling Compound
manufacturer’s recommendations).
READ
CAREFULLY
Read
material manufacturer’s instructions before mixing
6. Make sure Makinex Electric Mixer is switched to low gear (1
st
Gear) and speed 1.
7. Plug in Makinex Electric Mixer to extension cord to Mains Power.
8.
Press Trigger to turn ‘ON’ mixer and lock in Trigger.
9. Start adding Bags of Levelling Compound one at a time. The Bucket has bag rests that
can be used to support the weight of the Bags while pouring.
10. Leave Makinex Electric Mixer on low-speed gear (1
st
Gear). The mixing speed can also
be adjusted using the speed dial (there are six speeds)
11. After final bag of Levelling Compound has been added, STOP the Makinex Electric
Mixer and THEN switch to high-speed gear (2
nd
Gear). It may be necessary to rotate
the helix paddle forward and backwards slightly by hand to engage the gear. Restart
the mixer. It is not recommended to exceed speed 3 when in gear 2.
12. During mixing, wait for 30 seconds as the compound is being
mixed; turn ‘OFF’ Mixer
temporarily and scrape off any excess powder that has gathered around top of bucket.
NOTE: After the final bag of Levelling Compound has been added, the whole mixing
operation should take approximately 2 minutes.
Vacuum Port
Optional 38mm to
50mm adaptor
Hose to mains
water (not
included)
Trigger Lock & Trigger
High / Low
Gear
Selector
Speed dial 1-6