6
MakerBot Replicator
MakerBot
6
MakerBot Replicator
MakerBot
Four (4) socket cap heads
attaching the Lower Gantr
Brackets to the Linear Bearings.
Using a 1.5mm hex driver
Eight (8) buttons head screws (4
per rail) attaching the Gantry Rails
to the X Y Gantry Using a 1.5mm
hex driver
Remove the following screws:
Using a 2.0mm hex driver loosen
up the shoulder screws to remove
the Black Idler Pulleys.
Loosen the two (2) button
head screws holding down the
Tensioned Pulley Bracket using
a 1.5mm hex driver located on
the front left. Next using a T15 or
a 3mm hex driver loosen up the
Tensioning Bolt to give you enough
slack and remove the Belt.
Unclip the Belt Clip off the
Carriage adapter, using a 1.5mm
hex driver remove twelve (12)
button heads attaching the Upper
XY Bracket to the Lower Gantry
Brackets
(NOTE: Most belt are now glued
to the belt clip, it is possible to
remove the Belt Clip with out
damaging the belt. If belt is
damaged replace both Belt Clip
and Belt).
Step 9 - Remove Belt and Belt
Clip
•
•
•
•