MakerBot Replicator 2X, Устранение неисправностей и техническое обслуживание

Страница: 9 / 40

FILAMENT STUCK
Filament can swell inside the extruder and
get stuck. If you cannot unload filament
from one of the extruders, do the following:
1. Go to the LCD panel and select Utilities
> Filament Options > Unload. This option
heats the extruders.
2. Set the extruder arm to the open position.
3. Push about half an inch of filament
through the extruder to clear the blockage.
4. Try pulling the filament out of the
extruder again.
If you are unable to unload filament because
it has broken off inside the extruder, you
might not be able to reach inside the
extruder to clear the blockage. In that case,
see the section
Disassembling an Extruder.
PRINTING ISSUES
CONTINUED
9 TROUBLESHOOTING