MakerBot Replicator 2X, Устранение неисправностей и техническое обслуживание

Страница: 11 / 40

11 TROUBLESHOOTING
LCD ERROR MESSAGES
Error Message Description
Use the LCD menu to check your target
extruder temperatures. Navigate to Info and
Settings > Preheat Settings to make sure
the extruder temperatures are not set higher
than 300C.
If the extruder temperatures are set to
below 300C, contact MakerBot support.
To clear this message, you will have to
restart your MakerBot Replicator 2X.
Your MakerBot Replicator 2X has
automatically disabled its heaters after a
period of inactivity as a safety precaution.
Re-start your print or the preheat routine to
reset your heaters.
If your MakerBot Replicator 2X encounters problems during operation, the LCD menu will
display an error message. The following table describes each possible error message.
NOTE: If you see an error message in an unexpected context, please contact MakerBot Support by emailing
support@makerbot.com.