Major tech MT720, Инструкция по эксплуатации

Страница: 12 / 16

12
7.6. Frequency Measurements
2. Set the function switch to the V ~ HZ/% Position.
3. Press MODE button to select the Frequency (Hz) or Duty cycle (%).
4. Touch the test probe tips across the part under test.
5. Read the value on the display.
6. The display will indicate the proper decimal point and value.
1. lnsert the black test lead banana plug into the negative COM jack and
the red test lead banana plug into the V CAP TEMP Hz% Ω
positive jack.
4. Read the temperature on the display. The digital reading will indicate
the proper decimal point and value.
5. Use the MODE button to select °F or °C.
5. The diode or junction can be evaluated as follows:
• If both readings display OL the device is open.
1. Set the function switch to the TEMP position.
7.8. Diode Test
3. Touch the test probe tips to the diode or semiconductor junction
under test. Note the meter reading
7.7. Temperature Measurements
• If one reading displays a value (typically 0.400V to 0.900V) and
the other reading displays OL , the diode is good.
2. lnsert the Temperature Probe into the negative COM and the
V CAP TEMP Hz%
Ω
positive jacks, observing polarity.
2. Turn the function switch to Ω position. Use the MODE button
to select the diode function if necessary (diode symbol will appear
on the LCD when in Diode test mode)
1. lnsert the black test lead banana plug into the negative COM jack
and the red test lead banana plug into the V CAP TEMP Hz%
Ω positive jack
WARNING: To avoid electric shock, be sure the thermocouple
probe has been removed before changing to another measurement
function.
4. Reverse the test lead polarity by reversing the red and black leads.
Note this reading
3. Touch the Temperature Probe head to the device under test.
Continue to touch the part under test with the probe until the
reading stabilizes.
• If both readings are very small or '0', the device is shorted.