Majestic VF, Инструкция по установке и эксплуатации

Страница: 10 / 20

71D0531
10
VF/VFR Vent-Free Fireboxes
FIREpLACE and CANOpY INSTALLATION
When finishing a custom cabinet, mantel, or other built-in
enclosure, the opening size to accommodate the fireplace
with trim installed is as follows:
Figure 10 -
Custom Cabinet
A
B
FP2694
custom cabinet
VF/VFR32C VF/VFR36C VF/VFR42C
Ref. w/Trim w/Trim w/Trim
A 37
M\,
" 41
M\,
" 47
M\,
"
B 35
M\,
" 35
M\,
" 35
M\,
"
INSTALLING CANOpY
A canopy is furnished with each firebox and MUST be
installed for safe operation. Figure 11
1. Align the canopy with the holes in the top frame.
. Secure the screws as shown.
3. Tighten side screws. Make sure the canopy is level and
secure.
Figure 11 -
Installing Canopy
FP2451
install canopy
Screws
Canopy
FP451
W
ARNING
The firebox canopy must not be modified
or replaced with a canopy that may be
provided with the unvented decorative
room heater.
W
ARNING
Close fireplace screen panel before
operating a decorative type unvented room
heater.
1. Bend out the nailing flanges located on each side of the
firebox.
. Slide the firebox into prepared framing or position firebox
in its final position and frame later.
3. Level the firebox by checking the top edge of the firebox.
Shim if necessary.
4. Anchor firebox to the side framing members using 8d
nails or other suitable fasteners. Figure 9.
5. The canopy must be installed for safe operation of the
heater.
FP2902
nailing flanges
Nail Sides Through
Nailing Flanges
FP90
Figure 9 -
Location of Nailing Flanges