22
Vermont Castings, Majestic Products Chateau™
20006081
Volcanic Rock
LG292
Fig. 42 Place volcanic rock on lower refractory in front of
burner housing.
Ember Material
Small Lava Rock
LG293
Fig. 43 Place ember material on burner tube. Place small
lava rock 1
¹⁄₂
” on burner housing.
4. Holding the rear refractory lower straight up, rotate
it back behind the side refractory and set it on the
small return bend of the rear log bracket toward the
back of the firebox. Ensure the mortar lines in the
refractory match the side refractory already in-
stalled.
5. Rotate back and set on the rear log bracket toward
the back of the firebox.
6. The rear refractory upper has a notch in the top
side. Holding the refractory at an angle, slide the
refractory behind the side refractory installed.
7. While holding the rear refractory upper in place,
follow Step 3 and install the remaining side refrac-
tory.
8. Adjust all refractory pieces so mortar lines are
aligned. Replace heat shield removed in Step 2.
Make sure the angle on the heat shield goes back.
This will secure the side refractory in place.
9. Slide the right and left lower refractories into place
in front of the burner and align.
10. Reinstall the burner tube and fettle.
Log, Lava Rock and Ember Placement
Unpack the logs from packaging and remove each log
from its wrapping material.
The logs are fragile and should be
handled with care. Keep the packaging
materials out of the reach of children and
dispose of the material in a safe manner.
1. Ensure the two (2) screws that attach the fettle to
the burner are secure.
2. Set the andirons in place by hooking the tabs on the
back of the andirons over the outermost webs of the
fettle. (Fig. 41)
3. Place the volcanic rock over the lower refractory in
front of the burner tube and around the burner
assembly as desired. (Fig. 42)
4. Place the ember material lightly in front over the
burner tube. Cover the area between the burner
tube and the burner pan assembly. (Fig. 43)
Andirons
Fettle
Burner Tube
Burner
Housing
LG291
Fig. 41 Ensure fettle is securely attached to the burner
housing and set andirons in place.
5. Place the small lava rock 1
¹⁄₂
” (38mm) along the top
front edge of the burner pan assembly.
Refer to Figures 47 & 48 for final log positions.
6. Center the log rear onto the rear log bracket and
slide back until it comes in contact with the rear
refractory lower. (Fig. 44)
7. Hold the log front left with the narrower end toward
the right. For DVT44, set the log on the inside left
side of the fettle and bring it forward until the right
end of the log comes through the opening in the
fettle. For the DVT38, the log is placed the same,
however the end will not come through the fettle.
When in place, the left end of the log is supported
above the left sheet metal bracket. DVT38, the log
will just touch the left side refractory. (Fig. 45)
8. Hold the log right front with the pointed end toward
the left. Set the log on the inside right side of the
fettle and bring forward. The pointed end of the log
should come in contact with the front left log. When
in place, the right end of the log is supported above
the sheet metal bracket toward the right. (Fig. 45)
