21
Vermont Castings, Majestic Products Chateau™
20006081
Fresh Air Restrictor Plate Adjustment
1. Remove the glass.
2. Remove the logs, andirons and fettle.
3. Remove one side refractory (right or left) and
remove the rear upper and lower refractory in
reverse order of installation. (Refer to “Ceramic
Refractory Installation” section.)
4. Remove the rear log bracket by removing three (3)
screws. On some models you may be able to
loosen the screws and slide bracket to the left and
out. (Fig. 37)
Rear Log
Bracket
Remove
Screws
(3)
Fig. 37 Remove rear log bracket.
FP1411
5. Adjust the fresh air restrictor plate setting. (Fig. 38)
Simultaneously install the plate and the log bracket
using the three (3) screws loosened or removed
earlier. The adjustment is made by matching the
proper setting on the plate with the three (3) holes
on the firebox back.
6. Replace the rear lower and upper refractory, side
refractory, fettle, andiron, logs and glass.
1 2
3
Fresh Air
Restrictor Plate
FP1412
Fig. 38 Fresh air restrictor plate adjustment.
Ceramic Refractory Installation
The ceramic refractories are fragile and
should be handled with care. Due to the
size of the refractories, an assistant may
be helpful.
Left Side
Refractory
Rear Refractory
Upper
Rear Brick
Lower
RH Lower
Refractory
LH Lower
Refractory
Right Side
Refractory
FP1365
Fig. 39 DVT44 ceramic refractory panels.
1. Using a Phillips or Robertson screwdriver, unfasten
the two (2) screws holding the fettle to the burner
assembly. (Fig. 39) With a wrench, remove the front
burner tube by unfastening the two (2) nuts that
secure the burner tube to the front of the burner
assembly.
2. Using a Phillips or Robertson screwdriver, remove
the heat shield located toward the front top of the
fire box by unfastening the five (5) screws that
secure the heat shield in place. (Fig. 40)
Remove
Screws (5)
FP1369
Fig. 40 Remove five (5) screws securing heat shield in
place.
Return Flange
3. Start with either the right side refractory or left side
refractory. Hold the refractory at an angle. Slide and
seat the bottom edge toward the bottom of the
firebox. Tilt it carefully toward the side until the
piece is in place. Slide the refractory forward until it
comes in contact with the front flange on the
firebox.
