Majestic 500DVH Series, Инструкция по установке и эксплуатации

Страница: 22 / 72

56D3049
10
1
/
2
"
(267mm)
10
1
/
2
"
(267mm)
8
1
/
2
"
(216mm)
Combustible
Wall
Noncombustible
Wall
9
1
/
2
"
(241mm)
9
1
/
2
"
(241mm)
3
3
/
4
"
(92mm)
7
1
/
2
"
(190mm)
VENT INSTALLATION
1. Locate and cut the vent opening in the wall.
For combustible walls first frame in opening.
Combustible Interior Walls:
Cut a 12 1 ⁄
2
"H x
10 1 ⁄
2
" W hole through the interior wall.
Combustible Exterior Walls:
Cut a 10
1
⁄
2
"H
x 10 1 ⁄
2
"W square hole through the exterior
wall frame. See Figure 17.
Noncombustible Walls:
Hole opening should
be 8 1 ⁄
2
" (216mm) in diameter.
2. The center of the hole should line up with the
center line of the horizontal rigid vent pipe
end. Allow 1 /
4
" minimum rise per foot. See
Figure 26.
Figure 26 - Exterior Wall Framing Dimensions for 5"x8"
W
ARNING
You may use a reducer from
5"x8" to 4"x6 5 /
8
" for horizontal
with vertical rise application.
ONLY use framing instructions
below when using 4"x6 5 /
8
"
venting.
If the reducer is installed at
the rear of the unit, you must
immediately follow with a
90° elbow for a vertical rise
before continuing with any
horizontal run.
1. Locate and cut the vent opening in the wall.
For combustible walls first frame in opening.
Combustible Interior Walls:
Cut a 11 1 ⁄
2
"H x
9 1 ⁄
2
" W hole through the interior wall.
Combustible Exterior Walls:
Cut a 9 1 ⁄
2
"H
x 9 1 ⁄
2
"W square hole through the exterior
wall frame. See Figure 16.
Noncombustible Walls:
Hole opening should
be 7 1 ⁄
2
" (190mm) in diameter.
2. The center of the hole should line up with the
center line of the horizontal rigid vent pipe
end. Allow 1 /
4
" minimum rise per foot. See
Figure 27.
Figure 27 - Exterior Wall Framing Dimensions
for 4"x6 5 /
8
"
HORIzONTAL WITH VERTICAL RISE (THROUGH-THE-WALL) APPLICATIONS
NOTE: #1222DA reducer must be used when 4x6 5 /
8
" venting
is preferred. Reducer must be installed directly onto
unit at pipe adaptor before vertical rise.