Majestic 33BDVR, Инструкции по установке и руководство для владельца

Страница: 23 / 40

23
BDVR Series Direct Vent Gas Fireplace
10003357
43BDVR
Refer to Figure 41
1. Remove the top louvre assembly.
2. Remove the window frame assembly.
3. Fit the rear left log (BD11) onto the rear log support.
Ensure the back of the log is flat against the rear
wall of the support.
4. Fit the front left log (BD12) onto the left support
bracket over the burner housing assembly.
Ensure the log’s bottom holes are located onto
the two studs of the bracket.
5. Place the top center log (BD13) in position by
resting the hole under the top end of this log located
over the knob on the center of the rear log, while
the bottom end of the log with cut out will rest
against the back wall of the deflector.
6. Place the front right log (BD14) in place with the
front part of the log sitting against the back wall of
the deflector. Make sure the right front end of the
log is touching against the bend back of the deflec-
tor. Also the back end of this log will be reclined
onto the rear log.
7. Scatter the ember material over the front area of the
burner housing assembly. (Fig. 41) Do not pack this
material tightly, separate it when unpacked and keep
it in a loose condition.
8. Scatter the lava rock material around the firebox base.
Do not place any of the lava rock mate-
rial on the burner housing assembly.
39BDVR
Refer to Figure 40
1. Remove the top louvre assembly.
2. Remove the window frame assembly.
3. Fit the rear left log (BC10) onto the left side of the
rear log support. Ensure the log’s bottom holes are
located on the two studs of the support.
4. Fit the rear front and right log (BC13) onto the right
side of the rear log support. Ensure the log’s bottom
holes are located on the two studs of the support
and the front end of this log will be set onto the right
side of the burner housing assembly.
5. Fit front left log (BC11) onto the left support bracket
over the burner housing assembly. Ensure the log’s
bottom holes are located on the two studs of the
bracket.
6. Place the top right log (BC12) on top of the rear and
front right log by resting the pre-cut rectangular hole
under the end of this log located over the
rectangular knob on the rear and front right log.
7. Scatter the ember material over the front area of the
burner housing assembly. (Fig. 40) Do not pack this
material tightly, separate it when unpacked and
keep it in a loose condition.
8. Scatter the lava rock material around the firebox
base.
BC10
BC13
BC11
Embers
BC12
LG269
39BDVR
Fig. 40 39BDVR log placement.
Do not place any of the lava rock material
on the burner housing.
BD13
BD11
BD12 Embers
BD14
43BDVR
LG270
Fig. 41 43BDVR log placement.