9
majacraft
Starting with the right pedal (it will be on your left if you are facing the drive wheel), remove the
gold 25mm screw from the side of the pedal. Choose the conrod with the #1 stamped on the bottom
and push the green joiner through the hole in the pedal. It should protrude through the bottom of
the pedal about 1mm-2mm. Check the alignment of the outer rod end in the crank assembly. When
the rod end is aligned correctly, screw the 25mm screw back into place. The screw should only be
tightened until the head just touches the side of the pedal. DO NOT OVERTIGHTEN!
Now the left pedal (it will be on your right if you are facing the drive wheel), remove the gold 25mm
screw from the side of the pedal. Choose the remaining conrod and push the green joiner through
the hole in the pedal. It should protrude through the bottom of the pedal about 1mm-2mm. Check
the alignment of the rod end in the crank assembly as shown below. When the rod end is aligned
correctly, screw the 25mm screw back into place. The screw should only be tightened until the head
just touches the side of the pedal. DO NOT OVERTIGHTEN!
Align the holes on the drive wheel with the holes in the crank
assembly and screw it into place using the silver 32mm screws. It is
recommended that you insert the centre screw first.
Required:
2 - Gold 25mm (1”) screws
(in the pedals)
Posidrive screwdriver
10. Conrods to Pedals
Fit the green joiners in the wooden footmen to the pedals. We leave a mark on one conrod (a #1 on
the bottom end) and the right pedal (#1 by the screw hole) to ensure that each conrod is attached to
the correct pedal.
CORRECT
INCORRECT
9b
9c
10a
10b
