4
majacraft
Position the Base assembly on the flat surface. Now slide the Stem/
Handle assembly into the Base assembly and carefully align the stem
holes with the base side plate holes and the brace hole with the hole
underneath the base assembly.
Turn the handle assembly over so the small threaded hole near the handle pivot is on the bottom and
position the handle so it makes a 90 degree angle between the stem and handle. Using the T wrench,
carefully screw the 25mm JCB bolt in until it is tight.
Required:
3 - M6 30mm JCB (1 1/8”) bolts
(in the hardware bag)
4mm allen T wrench
(in the hardware bag)
Stem/Handle assembly
Base assembly
3. Attach stem to base assembly
Insert the JCB bolts through the holes and into the stem assembly.
Turn the base over and insert the JCB bolt in the hole underneath.
Partially tighten the bolts, checking that they are threaded in
correctly before finally tightening all bolts.
2c
2d
2e
3a
3b
3c
