MIEN3024/3026 Rack Mount Industrial Ethernet Switch
- 4 -
The Interface indication lights function:
PWR1
PWR2
ALARM
RUN
LINK/ACT
10/100M
Red on
Green
off
Green
flash
Green
periodic flash Green on Green flash
Green
on
Green
off
Power
normal
Both
power
supply
Single
power
supply
System
working
normal
Link
connected
Data
transmission 100M
10M
100M fiber connector
This switch has multi full duplex 100Base-FX single-mode or multi-mode
fiber connectors, the connector has 3 types SC, ST, or FC to be chosen. The
fiber connector is used in pairs, the TX is the transmitting port and the RX is the
receiving port. TX port is the optical transmitting end which is connected to the
optical receiving end RX of another remote switch optical interface; RX port is
the optical receiving end which is connected to the optical transmitting TX of
the same remote switch optical interface.
Below is the 100M fiber connector:
Ethernet RJ45 connector
This switch series has multi 10Base-T/100Base-TX Ethernet RJ45 ports.
Each port has adaptive function and support auto MDI/MDI-X connection. The
switch use straight-through network cables/crossover network cables to
connect to terminal devices, servers, hubs or other switches. Each port
supports IEEE802.3x adaptive, so the most suitable transmission mode (half
duplex or full duplex) and data rate (10Mbps or 100Mbps) can be automatically
selected (the connected device must also support this feature). If the devices
connected to these ports do not support auto-negotiation, the ports will send at
the correct speed, but the transmission mode will default to half-duplex.
The Power supply input terminal block
This series of switches standard configuration uses 2 channels of AC220V
redundant power supply, MIEN3024 and MIEN3024-4/8S/M, MIEN3026-2S/M
wiring terminals use 7.62mm pitch terminals to connect 2 power inputs.
