MIEN3024/3026 Rack Mount Industrial Ethernet Switch
- 5 -
MIEN3024-12/16/24S/M terminal block uses 5.08mm pitch terminal to connect
2 power inputs. The power consumption of the whole series is less than 25W
The Power supply input terminal block picture as below:
This series rack mount industrial Ethernet switch power requirement is as
below:
Voltage
Voltage
range
Working
temperature
Storage
temperature
Humidity
24vdc
18-36vdc
-40°C~+85°C
-40°C~+85°C
5~95%
48vdc
36-72vdc
-40°C~+85°C
-40°C~+85°C
5~95%
220vac/dc
85-264vac
47-63hz or
110-370vdc
-40°C~+85°C
-40°C~+85°C
5~95%
Notice:
The power supply specifications supported by this device are 24VDC,
48VDC, 220VAC/DC. Before connecting to the power supply, please confirm
whether the power supply is consistent as required to avoid damage to the
device
Alarm relay
The switch power-on and power-down alarm relay, the wiring terminal
adopts 3 5.08mm pitch terminals, this relay is one normally open and one
normally closed relay, as shown in the figure below. The one in the middle is
the common terminal, the two terminals on the left are normally open relays,
and the two on the right are normally closed relays. When the switch is
powered on and working normally, the normally open relay is energized and
closed, and the normally closed relay is disconnected. When the system is
powered off or one of the redundant power supplies is power off, the normally
open relay is powered off and the normally closed relay is closed. The
recommended switching load capacity of the relay is 1A (24VDC), Check below
